24 Hours to an Album

The new year is upon us, and that means it is the final day of my "deadline". Call it a self-fulfilling prophecy, or just call it too much for one month (during the holidays). Either way, looking back, through these posts, much progress has been made since the first iteration of the mixdowns. So with 12 hours left (approximately), let's see where we stand.

The master tracks are set up with the 5 band EQ that Anthony described earlier, and a simple insert chain on the stereo out channel. The critical part of the EQ setup was where the bands crossover. I found that adjusting the crossover between all the mid bands played a big role in which aspects of the mixes stood out. Adjust the mid/mid-high crossover too wide and the crunch of the guitars disappears, too narrow and the mix gets muddy. It will still need some fine tuning.

The insert chain of the stereo out channel, consists of Slate Virtual Console, UAD Pultec EQ, Izotope Ozone 5, and Slate FG-X compressor. The Virtual Console adds nice saturation and drive to the mix. I used the Pultec EQ to add some broad EQ bumps (very minimal), and just that insert being in there with neutral EQ adds a bit of presence. The Ozone 5 plugin has a few different modules, but I only use the harmonic exciter, Post-EQ, and stereo imaging. The slate FG-X compressor / maximizer is the last plugin in the chain, and is ultimately responsible for compressing and leveling the entire mix. I really like this plugin because it lets you push the mix pretty hard without distortion or that pumping over compression sound you hear on some albums. As you can see from the picture, I have the setting pretty modest to start. I've been trying to get everything sounding loud and punchy without having to turn the big "gain" knob up past 5. After doing a few variations of the settings and EQ on the masters, I compared the mixes to other metal bands I normally listen to. If you really listen, you can hear the vast differences between all the commercial mixes out there. I could also hear, doing some quick A-B tests, where my masters fall short. It is mostly in the upper mids where there is some presence lacking. I turned to the Isotope Post EQ to take a look at where my frequency band is "lacking". On the spectrum, my mix is in light green, and the frequency band of another commercial metal band, I actually don't remember who, is in purple. The red line is the EQ curve applied. Notice at the ends there are two sharp low and high brickwall EQ cuts. These are set at 30Hz and 18Khz respectively, and this is mainly because there isn't any important musical information at these frequencies. You can see that the other mix did the same on the high side. There are two small dips where I heard some muddy sounding frequencies. For the most part, the curves are right there together, but then there is a separation around 2.5Khz through to the end. That is the upper mids that need some work. Its one thing to hear the difference, and its a beautiful thing to SEE that difference. I now know where my focus should be on these masters.

So moving forward, I found the weak spot in the masters, and identified the weakness in the mixes with the snare drum. All in all, I think it was a productive month. Hopefully this last bit doesn't take the rest of this month. Happy New Year!

2 Days to an Album

Well, the holidays are over, and our deadline is approaching; 2014. The last week has been hard to find time to work on the masters, let alone, the original mixes. I spent an evening going over the EQ bands that Anthony had setup, and the overall compression of the master tracks, and found a few tweaks that I was happy with, but ultimately there was one thing in the mix that really keeps eluding me. The Snare.


Every mix down I do, I'm pretty happy with the result, but the snare drum still seems to slip back into the mix and get "stepped on". In metal, the kick / snare relationship are one of the most important things. They have to work together, much like any relationship, not be dysfunctional. Though in this case, I don't think it was the kick drum that was interfering. I used the track, Enticing the Tyrant as my test, mostly because it is under a minute thirty seconds. Once I have the settings down in this song, I can apply them globally.

I really spent time adjusting the EQ and transients of snare track. I used some subtractive EQ around 700Hz, and a narrow dip around 200Hz to get rid of some overtone, then a small High EQ shelf around 3KHz. Next was to add some saturation using the Steven Slate Virtual Console (VCC). This kind of rounds out the attack of the snare a bit, so to get that bite back, I used the UAD powered, SPL transient designer. This is a great tool that can add punch and sustain without over compression or clipping the track. After all of that, I made the decision to buss the snare to the same reverb as the toms instead of using one in the insert chain. I think this made the snare sound a bit more cohesive with the rest of the drums.

While I was in the mood of adjusting things. I also spent some time on the guitars. As with the snare, I really tried to find what frequencies were important, and what I needed to sculpt to make room for other instruments. The result was adjusting EQ and saturation on the individual tracks. Lastly, I made some minor adjustments to the EQ crossovers in the master track to accommodate the changes made to the snare and guitars. I present to you, the result. Still dialing it in.



After walking away for a bit, then taking a listen myself, I hear a few areas I still need to "clean up". One area is the low-mid. There is still some room for improvement and clarity to be gained. That is the goal for tomorrow - EQ cleanup.

9 Days to an Album

I know it seems like we've been MIA for the last 10 days or so, but actually a lot has been going on behind the scenes. While I've been away, Anthony, our faithful producer / engineer, has been diligently working on the rough masters for the tracks. The plan was to set up a 5 band EQ / compression for each track, basically sub-dividing the audio spectrum into 5 ranges, a low, low-mid, mid, high-mid, and high. Sounds easy, but the difficult part is deciding which frequency range should make up each section. There is also an area of overlap where each section crosses over into the next, and that is really the critical decision. Much like the mixing, this step takes some trial and error, along with subtle tweaks to really focus in on what sounds you are trying to accentuate, and which you are trying to attenuate. So, instead of myself trying to explain what Anthony did, I'll let him explain in today's video blog. Enjoy!

19 Days to an Album

Well it is Friday, and the focus of today was to get all the tracks mixed down. I applied all the current presets and vocal processing to each track, while keeping in mind that some songs will need a few tweaks of said vocal presets. For the most part though, they were a good starting point and offered the cohesion needed between tracks. It took a while to mix down everything to stereo. I probably spent a good 30-45 minutes on each track going through and removing silences and guitar noises, applying crossfades and fade outs where necessary, then getting a final overall mix.

I came back to the mixes hours later to take a final listen and jot down some notes for each song. I will go back once more and apply these minor fixes and then the tracks are in Anthony's hands. I'll have another sample up tomorrow. For now, enjoy the short, but sweet, Enticing the Tyrant.

20 Days to an Album

Most of today was spent going through more tracks. I have noticed that I've been more and more indecisive on how I want to do the vocal tracks. At first, I was dividing the heavy, clean, and FX tracks into separate groups and applying processing to the group and then sending those groups to a vocal buss for compression. Though, going through some later tracks I found it easier to just apply the any EQ, saturation, delay, reverb, etc., to the individual tracks, then just do the final buss compression on one group. THEN there was another track where I put compression on each track BEFORE the EQ, saturation and other processing. That sounded the best, but the compression was bringing out the worst in the plosives and "esss's". So, the result is I have 4 or 5 tracks now bounced down using different grouping and compression methods. The results are all very similar, but ultimately I need to decide on one method and stick with it. Right now I think I am just working out which is the best route to take. There are so many ways of getting to the same result, and if these were relatively simple vocal tracks, it would make it pretty easy, but the style differences between the screaming and singing make it almost impossible to use the same processing for both. The goal is to have both sound like the same source and most importantly, be cohesive. The goal tomorrow is to get the rest of the tracks bounced down to stereo mixes, and get the vocal situation sorted out. Tomorrow is the last full day I have before I need to get the tracks over to Anthony. Crunch time.

21 Days to an Album

This is post is 12 hours late, but last night's rehearsal and subsequent production meeting ran a bit late. We needed to make important decisions regarding specific tracks. It was mostly deciding which vocal harmonies or layers to keep, moving some parts around and picking specific production elements. The tracks in question were Black Box, Tragedy of the Commons, and Gozer. So with that out of the way, I can continue with all the mix downs and getting the tracks prepped. I will hand the stereo mix downs over to Anthony this weekend and he will begin the preliminary mastering. Once he is done, we can go back and make any necessary changes and go on to the last step. FINAL mixes and masters.

22 Days to an Album

Today was more productive than I expected it to be. I applied all the current presets to one more track, Ubiquitous Gaze. This song was a bit more complicated than the last few only because of the different vocal layers and FX. I ended up creating 3 vocal groups; Vocal Clean, Vocal Heavy and Vocal FX. The first two were almost identical except the Heavy one had some added elements to overdrive it a bit more. The FX group had extreme EQ to create the filter effect heard in the verse around 0:40. Then it was a matter of sorting which phrase needed to be sent to which group, which meant organizing track sends and then balancing it all out. There was even some automation necessary on the group for a long decay on a screaming part.

I also ended up re-tracking some guitars at the end to rearrange the outro. Before there were the two "groove" guitars panned left and right and one lead octave guitar in the center. So instead I put two rhythm tracks playing the chords panned left and right and the "groove" track in the center. I think it sounds much more balanced.

All in all, I think this track sounds the best so far. I even tweaked the EQ on the snare drum to be more surgical and corrective than musical. The result is a fuller sound bottom end on the snare which cuts through the mix better. Take a listen!


 

Tomorrow is a production meeting with the band and Anthony to go over some final changes that need to be made. If I have enough time, I'll get another track up.